MIA Gate D11 Grease Trap Replacement

Scope of Work shall include, but not be limited to: Provide all labor, equipment and materials for the demolition of the existing grease interceptor located at MIA Gate D11 and replacement with a new hydromechanical grease interceptor, solids separator, and sampling port, along with associated electrical and plumbing work and pavement restoration. CONTRACTOR shall review all documents, specifications, and scope of work provided by Miami-Dade Aviation Department (MDAD) for work to be completed. Please refer to the Plans for further description of the scope of work. MINIMUM QUALIFICATIONS AND EXPERIENCE: The selected contractor must possess: 1. Contractors must hold a valid license required to perform work in the following trade: General Contractor License. 2. As per Resolution No. R-1122-21, Contractors must have a minimum of 5 years’ experience performing work in their specific trade. In the event a new firm is established by executives, supervisors and other senior field staff (key employees) that would have met these minimum experience requirements with a prior firm, MDAD reserves the right to qualify the new firm, based on MDAD’s sole determination and evaluation of the knowledge and prior experience of these key employees employed by the new firm. 3. Contractors must be able to demonstrate that their firm or its key employees, as described above, have experience performing their respective trade within the company’s noted history. Specifically contractors must submit proof that their respective firms have been regularly and successfully engaged in work related to their specific trade for a minimum of one (1) year. MANDATORY PRE-BID MEETING & SITE VISIT: Since a conference call does not require a physical presence, social distancing practices for COVID-19 are being adhered to. Bidders are still required/responsible for participating in the MANDATORY conference call. Failure to participate in the MANDATORY conference call shall result in the corresponding contractor/company being considered non-responsive. Contractors are extremely encouraged to call 5 minutes before the scheduled meeting time for a roll call. Late arrivals to the conference call shall result in the contractor/company being considered non-responsive. The conference call will be recorded. The dial-in instructions for the conference call are described below: • Dial in: 305-876-8333 • Meeting ID: 5762555 • Passcode/Pin: 5869 The agenda for the pre-bid conference call meeting will be sent to you via email to be used during the meeting. Make sure you receive it, if not, please check your junk email or contact our office. Bidders are responsible for attending the mandatory pre-bid meeting conference call and site visit. Contractor must refer to the Request for Price Quotation (RPQ) and associated project documents for the detail Scope of Work.