Big Joe Furnace Parts Loader

The Department of the Air Force is seeking a Big Joe WS40 or equivalent parts loader for the 76th PMXG. The requested equipment must meet specific requirements, including an inverted design, rail guidance, and a 4,000 lb. capacity. The loader must also have forks with a length of 84 inches, a lowered height of approximately 43 inches from the floor, and a lift height of at least 12 inches above the lowered height. The straddles must be 70 inches in length, with a 40-inch ID and a 48-inch OD. • The equipment must have a 4,000 lb. capacity and a 500 lb. load at 54-inch load center. • The forks must be 3 x 3 solid bar forks with an OD of less than 48 inches and an ID between forks of greater than 30 inches. • The straddles must have a 4-inch width for each straddle leg. • All other dimensions may vary to meet the other requirements and dimensions listed above.